Ontario building code 2012
Level of Training Provided to Stakeholders Following Implementation of Code? The technical advisory committee then review and make recommendations to the minister. The advisory council is made up of stakeholders, initial comments are considered (informal) then there is a public consultation process, then feedback goes to the technical advisory committee. Involvement of Stakeholders in the Development of Codes Schemes and incentive programs are available. Incentives/Rewards to Encourage People to go beyond Minimum Level? Renewable energy produced can be credited against the allowed energy budget. Partially, no mandatory requirements at this stage, there are many local incentive programs where renewable systems are supported financially.
Life Cycle Assessment considered (embedded energy):.Site Energy - energy used onsite, renewable energy can be credited against total onsite energy used.
#ONTARIO BUILDING CODE 2012 SOFTWARE#
Using this approach the designer must use recognized energy simulation software (such as HOT2000 V9.34c1.2 or newer), and submit documents which show that the annual energy use of the building is equal to a prescriptive package. Performance refers to the alternative method of compliance - Energy Budget. Performance requirements are applicable if the design differs from the basic prescribed requirements, Sb-10 and SB-12. Partially, calculations are based on a comparison with a prescriptive package (reference building). Trade off method concerning the building envelope is available to large buildings. Energy efficiency design modeling and testing of the building is not required under this option. Prescriptive requires that the building conforms to a package of thermal insulation, window and mechanical system efficiency requirements. Predominantly prescriptive requirements, Sb-10 and SB-12. Since then, Ontario has continued to improve requirements with the current code including many dynamic aspects low maximum U-value requirements, minimum efficiency requirements for most systems, strict air-tightness and thermal bridging requirements, increased performance labeling through EnerGuide, performance-based requirements for residential buildings undergoing renovation, code development overseen by a technical advisory committee and well implemented dissemination of training and information to the public. Ontario has a long history of building energy codes with the first code for energy efficiency of buildings being released in 1975. Compliance can be shown through meeting prescriptive measures or an alternative simulated (reference building) performance method. Both sections address the thermal envelope requirements and energy consumption is addressed through performance requirements for most systems including, heating, cooling, ventilation, hot water systems and lighting (SB-10 only). The building code is a provincial regulation that applies across Ontario. The current building energy code is Part 12 of the Ontario Building Code, which is split in to two sections (2012 amendments), SB-10 for large buildings and SB-12 for Housing (3 stories or less).